Submit a request
Sign in
  1. Trus Joist Technical Support
  2. Installation
  3. TJI® Joist Installation

Can I cut oval holes in TJI® joists?

Follow

Yes.  Oval (or slotted) holes can be designed in Forte software or the equivalent rectangular holes can be verified using the chart on page 9 of the TJI Specifier's Guide.  

  • Facebook
  • Twitter
  • LinkedIn
Was this article helpful? 0 out of 1 found this helpful

Have more questions?

Submit a request
Return to top

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

  • Where can I put holes in a TJI® joist?
  • What if the edge of a TJI® web hole is immediately adjacent to the face of the flange?
  • Should TJI® Joists Lap or Butt Over Intermediate Bearings?
  • Is there a top or bottom to a TJI® joist?
  • Can I cut oval holes in TJI® joists?
  • How far can you shift a TJI® Joist?
  • Can TJI® Joists be Used for an Outdoor Deck?
  • Attachment Connections to TJI® Joist Bottom Flange
  • Solar Panel Attachement to TJI® Joist
  • Are my TJI® Joists causing my floor to squeak?

Related articles

  • Where can I put holes in a TJI® joist?
  • Repair detail for TJI® joists with holes too close to bearing
  • How far can you shift a TJI® Joist?
  • Is there a top or bottom to a TJI® joist?
  • Attachment Connections to TJI® Joist Bottom Flange

Can’t find what you’re looking for?

Submit a request
  • Weyerhaeuser Home
  • Timberlands
  • Recreation
  • Land
  • Wood Products
  • Energy
  • Sustainability
  • Investors
  • Careers
  • Company
  • Weyerhaeuser Japan
  • Submit Ideas and Inventions
  • Privacy Policy
  • Legal Notices
© 2019 Weyerhaeuser Company. All Rights Reserved.